[Solved] he problem of the VOH(min) of a TTL IC being too low to drive a CMOS circuit and meet the CMOS requirement of VIH(min) is usually easily overcome by:

Computer Science Engineering (CSE)
Digital Electronics and Logic Design
he problem of the VOH(min) of a TTL IC b...

Q.	he problem of the VOH(min) of a TTL IC being too low to drive a CMOS circuit and meet the CMOS requirement of VIH(min) is usually easily overcome by:
A.	adding a fixed voltage- divider bias resistive network at the output of the ttl device
B.	avoiding this condition and only using ttl to drive ttl
C.	adding an external pull- down resistor to ground
D.	adding an external pull-up resistor to vcc
Answer» D. adding an external pull-up resistor to vcc

View all MCQs in: Digital Electronics and Logic Design

Discussion

Related Questions

The problem of different current requirements when CMOS logic circuits are driving TTL logic circuits can usually be overcome by the addition of:
One advantage TTL has over CMOS is that TTL is
A TTL NAND gate with IIL(max) of –1.6 mA per input drives eight TTL inputs. How much current does the drive output sink?
What causes low-power Schottky TTL to use less power than the 74XX series TTL?
A standard TTL circuit with a totem-pole output can sink, in the LOW state (IOL(max)),
As a technician you are confronted with a TTL circuit board containing dozens of IC chips. You have taken several readings at numerous IC chips, but the readings are inconclusive because of their erratic nature. Of the possible faults listed, select the one that most probably is causing the problem.
It is best not to leave unused TTL inputs unconnected (open) because of TTL's
Ten TTL loads per TTL driver is known as:
Which logic family combines the advantages of CMOS and TTL?
The nominal value of the dc supply voltage for TTL and CMOS is