A cylindrical bar 10 metres long elongates 0.1 mm under a load. The strain in the material of the bar will be

Related MCQs

• Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is
• A machine requires an effort of 10 kg to lift a load of 250 kg and an effort of 13 kg for a load of 400 kg. The effort required to lift a load of 500 kg will be
• The displacement of a particle under going rectilinear motion along the x-axis is given by x = 2t3 + 21t2 + 60t + 6 metres.
• The piston of a steam engine moves in S.H.M. The crank rotates at 180 r.p.m. and the stroke length is 2 metres. The linear velocity of the piston when it is at a distance of 1 metre from the centre is
• A ball is allowed to fall freely from a height of 3 metres on to a fixed plate. If the successive rebound heights are h1, h2, h3
• The torque of 50 Nm is applied on the wheel operating a valve. If the wheel is rotated through two revolutions, work done in Newton-metres is given by
• The area under stress-strain curve represents
• A 2 m long shaft rotates about one end at 20 rad/s. It begins to accelerate with ? = 10 rads/s2. After how long, in seconds, will the velocity of the free end reach 100 m/s?
• A single purchase crab has a handle 45 cm long and a drum of 25 cm diameter. The pinion has 30 teeth and spur has 150 teeth. The efficiency of the machine is 75%. If the maximum force that can be applied is 500 newtons, the maximum load that can be lifted will be
• A dash pot consists of a cylinder 10 cm in diameter in which slides a piston 12 cm long having a radial clearance of 1 mm. The cylinder is filled with oil having a viscosity of 1 poise. What will be the resistance offered by the piston to sliding with a velocity of 3 cm/sec