The torque of 50 Nm is applied on the wheel operating a valve. If the wheel is rotated through two revolutions, work done in Newton-metres is given by

Related MCQs

• A grinding wheel rotates at 3000 rpm. When power supply is cut-off the wheel stops in 10 seconds. The number of revolutions made by the wheel before coming to rest would be
• A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming to rest would be
• A wheel accelerates from rest with an acceleration of 6 rad/sec2. How many revolutions are experienced in 4 seconds?
• A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was
• In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
• In a single threaded worm and worm wheel the number of teeth on the worm wheel is 60. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
• A couple applied to a flywheel of mass 5 kg and of radius of gyration 20 cm produces an angular acceleration of 4 radians/sec2. The torque applied in dyne cm is
• The number of revolutions through which a pulley will rotate from rest if its angular acceleration is increased uniformly from zero to 12 rad per sec2 during 4 sec and then uniformly decreased to 0 rad per sec2 during the next 3 sec would be
• A flywheel starting from rest and accelerating uniformly performs 25 revolutions in 5 sec. Its angular velocity in rpm after 10 seconds would be
• The work done in sliding a block of weight of 50 kg up a plane inclined at an angle of 30? to the horizontal so that the block is lifted through 1 m