A 2 MHz signal is applied to the input of a J-K lip-lop which is operating in the 'toggle' mode. The frequency of the signal at the output will be

Related MCQs

• An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?
• When an input signal A=11001 is applied to a NOT gate serially, its output signal is
• 8: A JK flip-lop has its J input connected to logic level 1 and its input to the Q output. A clock pulse is fed to its clock input. The flip-lop will now
• A J-K lip-lop has its J-input connected to logic level 1 and its input to the Q output pulse is fed to its clock input the flip-flop will now
• Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit
• A toggle operation cannot be performed using a single
• The minimum time for which the input signal has to be maintained at the input of flip-flop is called of the flip-flop.
• THE FOUR OUTPUTS OF TWO 4-INPUT MULTIPLEXERS, CONNECTED TO FORM A 16-INPUT MULTIPLEXER, ARE CONNECTED TOGETHER THROUGH A 4-INPUT                   GATE
• If an S-R latch has a 1 on the S input and a 0 on the R input and then the S input goes to 0, the latch will be
• 9: Consider an RS lip-lops with both inputs set to 0. If a momentary '1' is applied at the input S,then the output