A solid shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be

Related MCQs

• A solid shaft and a hollow shaft are to be of equal strength in torsion. The hollow shaft is to be 10% larger in diameter than the solid shaft. The ratio of the weight of the hollow shaft will be (both shafts being made of same material)
• In case the diameter of a shaft is doubled, its torque transmitting capacity will increase by
• A key and a shaft are made from the same material. The key is rectangular with a width of D/4 and a height of 3D/16. The shaft is under torsion only. The necessary length of the key for equal strength of the shaft and key will be
• If a square key and the shaft are to be of the same material and of equal strength, the length of key would be (d = dia. Of shaft)
• Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
• The uniform rate of descent is maintained by a brake on the drum which applies the necessary torque of 300 kg-m what additional brake torque is required to bring the system to rest in 0.50 second?
• The frictional horse power loss in a bearing having 25 mm diameter subjected to a load of 200 kg rotating at 600 rpm will be of the order of
• A circulating water pump of a condenser is of the centrifugal type and directly connected to a three phase induction motor running at 900 rpm. The pump delivers 30,000 litres per minute against the dynamic head of 10 m. The horse power of the motor required to drive the pump would be
• A key that transmits power through frictional resistance only is
• Which of the following key transmits power through frictional resistance only