The frictional horse power loss in a bearing having 25 mm diameter subjected to a load of 200 kg rotating at 600 rpm will be of the order of

Related MCQs

• A circulating water pump of a condenser is of the centrifugal type and directly connected to a three phase induction motor running at 900 rpm. The pump delivers 30,000 litres per minute against the dynamic head of 10 m. The horse power of the motor required to drive the pump would be
• The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to
• Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
• The pin supporting the exhaust iever of an internal combustion engine is subjected to a shear load of 400 kg/sq-cm the diameter of the pin should be
• Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
• A cantilever beam of square section is subjected to a load W at the free end. If the length of the beam is increased and load reduced to half the deflection at the free end as compared to original deflection would be
• In case of springs in order to achieve greater load carrying capacity when the outer diameter is limited
• In a ball bearing a ball is subjected to
• The advantage of needle roller bearing over ball bearing is
• A key that transmits power through frictional resistance only is