For design purpose a spur gear tooth is considered

Related MCQs

• Maximum gear ratio in case of single mesh spur gears is expected to be around
• For very heavy loads which of the following gear tooth profile will be preferred?
• Abrasion wear of gear tooth occurs due to
• The thickness of a gear tooth is measured
• The pressure angle an involute gear profile gear
• Operation of helical gears is silent and quiet while the operation of the spur gears is noisy because
• In case of spur gears the higher pressure angle results in
• In case of spur gears, the back lash depends on
• Friction losses in spur gears may be of the order of
• In gear design, addendum is equal to