The plastic design of a steel structure based on which of the following unsafe?

Related MCQs

• The plastic design of steel structures which is based on the statical method of plastic analysis is
• The plastic design of steel structures which is based on upper bound theorem is
• The plastic design of a structure based on which of the following is always safe?
• The number of plastic hinges necessary to convert a framed structure into a mechanism is (r is degree of redundancy of the structure)
• In case the number of plastic hinges at failure is less than (r+1), where r is the degree of redundancy of the structure then the type of collapse of structure is
• For the plastic analysis, the criterion for the analysis of a structure is based upon
• The basic design stress adopted for the design of light gauge steel members is
• The ratio of the plastic moment capacity to the yield moment capacity of a rolled steel beam section is about
• The maximum strain at the end of plastic range of structural steel is about
• The value of load factor which accounts for margin of safety in plastic design for gravity loads is about