The value of load factor which accounts for margin of safety in plastic design for gravity loads is about

Related MCQs

• The plastic design of steel structures which is based on the statical method of plastic analysis is
• The plastic design of steel structures which is based on upper bound theorem is
• The plastic design of a structure based on which of the following is always safe?
• The plastic design of a steel structure based on which of the following unsafe?
• The assumption of bi-linearly idealised stress-strain relationship for plastic analysis and design is used for
• In plastic analysis, the shape factor of a triangular section is
• In a central heating system, the seamless copper tubing used has an inside diameter of 20 mm and a wall thickness of 0.6 mm. For a maximum pressure of 1750 Kpa, when allowable stress is 225 Mpa, the safety factor will be
• A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
• For very heavy loads which of the following gear tooth profile will be preferred?
• Which of the following material is not suitable for impact loads?