In case of turning or milling, the surface roughness is expected to be in the range

Related MCQs

• The surface roughness on a drawing is represented by
• For simple turning operation of lathe, the cutting speed is specified as 70 metres per minute. The cutting tool may be expected to be
• Cutting speed in turning operations is maximum in case of
• With electronic circuits the accuracy that can be expected from scanners will lie in the range of
• At what rpm should a lathe be run to give a cutting speed of 25 m/min. When turning a rod of diameter 32 mm.
• When 50 mm rod is turning at a spindle speed of 200 rpm the cutting speed would be
• Which turning aluminium the side rake angle is nearly
• Which one of the following methods can be used for turning external tapers only?
• Back rake angle while turning brass is
• Which one of the following methods cannot be used for turning internal tapers?