A 10 mm mild steel rod 40 min long lying on ground will be known as

Related MCQs

• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• If an axial force of 15 kN is applied to a rod of 25 mm diameter, length 300 mm, the change in length of the rod was observed to be 0.045 mm. The modulus of elasticity of the material is 200 GPa. The strain in the rod will be ____ _.
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• A steel rod of 3m is manufactured at 250C the temperature of rod is increases to 1250C. If free expansion is 3.6mm, what is the temperature stresses produced if 1.5mm expansion is permitted?
• A steel rod of 3m length is manufactured at 250C the temperature of this rod increases to 1250C. What is the free expansion? Take E=200Gpa, α=12*10-6/0C,diameter=12mm
• Euler's formula for a mild steel long column hinged at both ends is not valid for slenderness ratio
• A brittle steel rod is heated to 160?C and then suddenly clamped at both ends. It is then allowed to cool and breaks at a temperature of 85?C. If E = 200 GN/m2 and ? = 12 x 10-5 / ?C, the breaking stress of steel is
• A steel rod of cross sectional area equal to 1000 mm2 is 5 m long. If a pull of 100 kN is suddenly applied to it, then the maximum stress intensity will be
• If L be the length and D be the diameter of cylindrical rod, then volumetric strain of the rod is equal to