The kern of a circular section of diameter D is a concentric circular area of diameter

Related MCQs

• An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
• Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
• An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
• Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
• A solid circular shaft of diameter D carries are axial load W. If the same load is applied axially on a hollow circular shaft of inner diameter D/2, the ratio of stress in a solid shaft to a hallow one is
• The portion, which should be removed from top and bottom of a circular cross section of diameter d in order to obtain maximum section modulus, is
• Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
• Two beams, one of circular cross-section and other of square cross-section, have equal areas of cross-section. If subjected to bending
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _