A uniform steel rope 400 metres long is hung vertically. The weight of the steel is 7.8 gm/cm3 and D = 2100 kg/mm2. The ratio of elongation of first 150 metres to that of first 300 metres would be

Related MCQs

• A flitched beam consists of a wooden joist 150 mm wide and 300 mm deep strengthened by steel plates 10 mm thick and 300 mm deep one on either side of the joist. If modulus of elasticity of steel is 20 times that of wood, then the width of equivalent wooden section will be
• A mild steel flat 3 m long 150 mm wide and 15 mm thick carries an axial tensile load of 150 kN. If the value of u for mild steel is 0.3, it can be concluded that
• A steel wire is hang vertically under its own weight. What is the greatest length it can have if the allowable tensile stress is 2000 kg/cm2 and specific weight of steel is 8000 kg/cm
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• If percentage elongation of a certain specimen made of a material 'A' under tensile test is 30% and the percentage elongation of a specimen with same dimensions made of another material 'B' is 40%, then material 'B' is more ductile than material 'A'.
• Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
• A stepped bar of steel consists of a pmormtion with cross section area 500 mm2 connected to a portion with cross section area 1000 2. Each portion has a length of 1 m. The modulus of elasticity of steel is 200 GPa. The maximum elongation of the bar by applying an axial tensile force at the ends without exceeding a stress of 100 MPa is    mm.
• Two bars of different materials and same size are subjected to the same tensile force. If the bars have unit elongation in the ratio of 2 : 5, then the ratio of modulus of elasticity of the two materials will be
• Two bars of sifferent materials are of the same size and are subjected to same tensile forces. If the bars have unit elongation in the ratio of 7 : 3, then the ratio of modulii of elasticity of the two materials is
• A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be