A strip of steel 75 mm wide 40 mm thick is bent round a circular drum of 4.96 m outside diameter. If E = 2 x 105 N/mm2, the maximum stress due to bending will be

Related MCQs

• A spring steel ribbon 3.2 mm wide, 0.5 mm thick is wound on a 500 mm diameter cylinder. If E = 2 x 105 N/mm2, the maximum stress in the steel will be
• A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to
• At a point in a steel member, the major principal stress is 2000 kg/cm2 and the minor principal stress is compressive. If the uni-axial tensile yield stress is 2500 kg/cm2, then the magnitude of the minor principal stress at which yielding will commence, according to the maximum shearing stress theory, is
• Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
• A steel strip is welded to a copper strip of the same dimensions along the length. The coefficient of thermal expansion for copper is greater than that for steel. If temperature is increased, ___ .
• Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
• A solid circular shaft of diameter D carries are axial load W. If the same load is applied axially on a hollow circular shaft of inner diameter D/2, the ratio of stress in a solid shaft to a hallow one is
• An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
• An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
• In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress is always a tensile stress where as the radial stress is a compressive stress