A load of 10,000 kg is applied to copper cylinder 20 cm long and 5 cm in diameter causes the length to increase by 4 mm and diameter to decrease by 0.4 mm. The Poisson's ratio for copper would be

Related MCQs

• An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
• An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
• A solid circular shaft of diameter D carries are axial load W. If the same load is applied axially on a hollow circular shaft of inner diameter D/2, the ratio of stress in a solid shaft to a hallow one is
• Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
• The Young's modulus of a material is 125 Gpa and Poissons ratio is 0.25. The modulus of rigidity of the material is
• For which of following material the value of Poissons ratio is more than 1?
• the extension per unit length of the rod due to suddenly applied load as compare to same load gradually applied to same rod is
• A short, hollow cast iron cylinder with a wall thickness of 1 cm is to carry a compressive load of 10 tonnes. If the working stress in compression is 800 kg/cm2, the outside diameter of the cylinder should not be less than
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm
• The ratio of stress produced by suddenly applied load to that produced by the same load when gradually applied is