A dead load is

Related MCQs

• There is always a limiting value of load up to which the strain totally disappears on the removal of load; the stress corresponding to this load is called…………
• A uniformly distributed load may be assumed to behave like a point load at the centre of gravity of the load for all sorts of calculations.
• If the working load is one third of the ultimate load, the factor of safety is
• the extension per unit length of the rod due to suddenly applied load as compare to same load gradually applied to same rod is
• If a prismatic member with area of cross-section A is subjected to a tensile load P, then the maximum shear stress and its inclination with the direction of load respectively are
• A beam ABC rests on simple supports at A and B with BC as an overhang. D is centre of span AB. If in the first case a concentrated load P acts at C while in the second case load P acts at D, then the
• A cantilever beam carries a uniformly distributed load from fixed end to the centre of the beam in the first case and a uniformly distributed load of same inten¬sity from centre of the beam to the free end in the second case. The ratio of deflections in the two cases is
• When both ends of a column are fixed, the crippling load is P. If one end of the column is made free, the value of crippling load will be changed to
• A short column of external diameter of 250 mm and internal diameter of 150 mm carries an eccentric load of 1000 kN. The greatest eccentricity which the load can have without producing tension anywhere is
• A load which acts at a point on a beam is not called uniformly distributed load.