The material preferred for the fabrication of fruit juice concentrator is

Related MCQs

• Fresh orange juice contains 12% (by weight) solids and the rest water 90% of the fresh juice is sent to an evaporator to remove water and subsequently mixed with the remaining 10% of fresh juice. The resultant product contains 40% solids. The kg of water removed from 1 kg fresh juice is
• Which evaporator is preferred for concentrating the fruit juice?
• Fruit juice (a heat sensitive material) can be concentrated in a __________ evaporator.
• In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2 /kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
• In sugar mills cane juice is evaporated in
• A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of material A is twice that of B. Under the equilibrium, the temperature difference across the wall is 36°C. The temperature difference across the layer A is __________ °C.
• A composite flat wall of a furnace is made of two materials 'A' and 'B'. The thermal conductivity of 'A' is twice of that of material 'B', while the thickness of layer of 'A' is half that of B. If the temperature at the two sides of the wall are 400 and 1200°K, then the temperature drop (in °K) across the layer of material 'A' is
• A wall has two layers A and B, each made of a different material. Both the layers have the same thickness. The thermal conductivity of material of A is twice that of B. Under the thermal equilibrium the temperature difference across the wall is 30?C. The temperature drops in layers A and B will be respectively
• Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
• Open pan evaporators are preferred to be used, when the solution to be concentrated is