In daisy chaining device 0 will pass the signal only if it has                 

Related MCQs

• The method of synchronising the processor with the I/O device in which the device sends a signal when it is ready is?
• The signal sent to the device from the processor to the device after receiving an interrupt is                         
•               interrupt method uses register whose bits are set separately by interrupt signal for each device.
• The signal used to initiate device select                   
• The side of the interface circuits, that has the data path and the control signals to transfer data between interface and device is            
• The MSYN signal is initiated
• In the output interface of the parallel port, along with the valid signal                is also sent.
•            signal is sent by the initiator to indicate the duration of the transaction.
•               signal is used to enable commands.
• IRDY# signal is used for