[Solved] You want to enable both arpa and snap encapsulation on one router interface. How do you do this?

McqMate

Q.	You want to enable both arpa and snap encapsulation on one router interface. How do you do this?
A.	the interface can handle multiple encapsulation types with no extra configuration
B.	assign two network numbers, one for each encapsulation type
C.	enable novell-ether to run multiple encapsulation types
D.	both arpa and snap are enabled by default so you don’t have to configure anything
Answer» B. assign two network numbers, one for each encapsulation type
Explanation: to assign multiple network numbers, you usually use sub interfaces. a sample configuration follows: ipxethernet

3.2k

0

Do you find this helpful?

21

View all MCQs in

Computer Architecture and Organization

Discussion

No comments yet

Related MCQs

As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this?
Consider a situation in which you are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem?
0.0.0 router IGRP 109 network 172.68.7.0
In OSPF database descriptor packet, which field is used to indicate that the router is master?
As a system administrator, you want to debug IGRP but are worried that the “debug IP IGRP transaction” command will flood the console. What is the command that you should use?
The layer, which provides the interface that client and server application objects use to interact with each other.
A wireless network interface controller can work in
Common gateway interface is used to
A typical program obtains a remote reference to one or more remote objects on a server and then invokes methods on them.
A list of protocols used by a system, one protocol per layer, is called