As a system administrator, you want to debug IGRP but are worried that the “debug IP IGRP transaction” command will flood the console. What is the command that you should use?

Related MCQs

• Consider a situation in which you are a system administrator on a NetWare network, you are running NetWare 4.11 and you cannot communicate with your router. What is the likely problem?
• 0.0.0 router IGRP 109 network 172.68.7.0
• As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this?
• You want to enable both arpa and snap encapsulation on one router interface. How do you do this?
• What does the “IPX maximum-paths 2” command accomplish?
• A subset of a network that includes all the routers but contains no loops is called
• In Multicast Routing Protocol, flooding is used to broadcast packets but it creates
• Most packet switches use this principle
• In Novell’s use of RIP, there are two metrics used to make routing decisions. Select the correct metrics.
• IPv6 does not use                    type of address.