Gain of power amplifiers                      with increase in operating frequency.

Related MCQs

• In conventional amplifiers, a flat gain response is achieved at the cost of reduced gain. But this drawback can be overcome by using:
• Klystron amplifiers have high noise output as compared to crossed field amplifiers.
• High gain is not achievable at microwave frequencies using BJT amplifiers because:
• If a power amplifier has an output power of 10 W, and an amplifier gain of 16.4 dB, then the input drive power is:
• In the plot of reactance v/s frequency of a crystal oscillator, the reactance between series resonant frequency and parallel resonant frequency is:
• If a frequency multiplier has a multiplication factor of 10, then the increase in noise level due to frequency multiplication is:
• Power amplifiers in the increasing order of efficiency is:
• Behavior of a transistor in power amplifiers is unpredictable at all input signal levels.
• With an increase in operating frequency, the background noise temperature:
•                        amplifiers are linear circuits, where the transistor is biased to conduct over the entire range of the input signal cycle.