[Solved] When deriving the transfer function of a linear element

McqMate

Q.	When deriving the transfer function of a linear element
A.	both initial conditions and loading are taken into account
B.	initial conditions are taken into account but the element is assumed to be not loaded
C.	initial conditions are assumed to be zero but loading is taken into account
D.	initial conditions are assumed to be zero and the element is assumed to be not loaded
Answer» C. initial conditions are assumed to be zero but loading is taken into account
Explanation: when deriving the transfer function of a linear element only initial conditions are assumed to be zero, loading cannot be assumed to be zero.

2.2k

0

Do you find this helpful?

30

View all MCQs in

Control System Engineering (CSE)

Discussion

No comments yet

Related MCQs

Determine the sensitivity of the overall transfer function for the system shown in the figure below, at w=1 rad/sec with respect to the feedback path transfer function.
A transfer function has two zeroes at infinity. Then the relation between the numerator(N) and the denominator degree(M) of the transfer function is:
From the following graphs of the generalized transfer function 1/s+a, which plot shows a transfer function with a bigger value of a?
From the following graphs of the generalized transfer function 1/as2, which plot shows the transfer function for a higher a?
A linear system at rest is subject to an input signal r(t)=1-e-t. The response of the system for t>0 is given by c(t)=1-e-2t. The transfer function of the system is:
Use mason’s gain formula to find the transfer function of the given signal flow graph:
Use mason’s gain formula to find the transfer function of the following signal flow graph:
Signal flow graphs are reliable to find transfer function than block diagram reduction technique.
Use mason’s gain formula to calculate the transfer function of given figure:
Use mason’s gain formula to find the transfer function of the given figure: