Knuckle Joint can’t be used to connect two intersecting rods.

Related MCQs

• If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.
• Two steel rods connected by cotter joint are subjected to 50 kN load each. What is the minimum diameter required of the rods? (Given: Yielding Stress= 400N/mm² ; Factor of Safety=6)
• Cotter joint can be used to connect two rods for torque transmission purpose.
• A knuckle joint is also called socket pin joint.
• A knuckle joint is unsuitable for two rotating shafts, which transmit torque
• A knuckle joint can be used in valve mechanism of a reciprocating engine.
• A maximum of how many roads may be connected using a knuckle joint?
• Which of the following are important parts of knuckle joint?
• Can the cotter joint be used to connect slide spindle and fork of valve mechanism?
• Miter gears are the bevel gears mounted on shaft which are intersecting at angle greater than 90.