- Civil Engineering
- Engineering Graphics
- While cutting, if the plane is at an ang...

Q. |
## While cutting, if the plane is at an angle and it cuts all the generators, then the conic formed is called as |

A. | circle |

B. | ellipse |

C. | parabola |

D. | hyperbola |

Answer» B. ellipse | |

Explanation: if the plane cuts all the generators and is at an angle to the axis of the cone, then the resulting conic section is called as an ellipse. if the cutting angle was right angle and the plane cuts all the generators then the conic formed would be circle. |

View all MCQs in:
Engineering Graphics

- A regular cone is resting on V.P with axis perpendicular to it a plane is cutting the cone such that it is perpendicular to H.P and inclined to V.P cutting cone at all generators the section formed is
- A regular cone is been cut by a plane which is inclined to axis of cone and cuts all the generators the section formed be like
- A line of 12 cm length is perpendicular to profile plane and the least distance from this line to profile plane is 6 cm. This is at a distance of 4 cm from the vertical plane and 5 cm from the horizontal plane. What is distance from the point on line far away from the profile plane to profile plane?
- When the plane cuts the cone at angle parallel to the axis of the cone, then is formed.
- The cross-section is a when a plane is inclined to the axis and cuts all the generators of a regular cone.
- A line of length 10 cm at first lied on the horizontal plane parallel to vertical plane and then keeping one of its ends fixed turned 30 degrees with respect to vertical plane and then turned 45 degrees with respect to horizontal plane. What is the length of line in top view?
- A line of length 10 cm at first lied on the horizontal plane parallel to vertical plane and then keeping one of its ends fixed turned 30 degrees with respect to vertical plane and then turned 45 degrees with respect to horizontal plane. What is the length of line in front view?
- A line of length 15 cm at first lied on the vertical plane parallel to horizontal plane and then keeping one of its ends fixed turned 30 degrees with respect to horizontal plane and then turned 50 degrees with respect to vertical plane. What is the length of the line in top view?
- A line of length 20 cm at first lied on the profile plane parallel to vertical plane and then keeping one of its ends fixed turned 40 degrees with respect to vertical plane and then turned 20 degrees with respect to profile plane. What is the length of the line in top view?
- A line of length 20 cm at first lied on the profile plane parallel to the vertical plane and then keeping one of its ends fixed turned 40 degrees with respect to vertical plane and then turned 20 degrees with respect to profile plane. What is the length of the line in side view?

Login to Continue

It will take less than 2 minutes

Report MCQ