- Civil Engineering
- Design of Steel Structures
- Bending compressive and tensile stresses...

Q. |
## Bending compressive and tensile stresses respectively are calculated based on |

A. | net area and gross area |

B. | gross area and net area |

C. | net area in both cases |

D. | gross area in both cases |

Answer» B. gross area and net area |

View all MCQs in:
Design of Steel Structures

- The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is
- The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is
- The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
- The moment of the couple set up in a section of a beam by the longitudinal compressive and tensile force, is known as
- The moment of the couple set up in a section of a beam by the longitudinal compressive and tensile force, is known as
- In a built up beam actual bending compressive stress fbc is given by (when y1 is the distance of the edge of the beam from the neutral axis).
- In a built up beam actual bending compressive stress fbc is given by (when y1 is the distance of the edge of the beam from the neutral axis).
- If fbt and fc are the co-existent bending tensile stress and shear stress in a member, the equivalent stress fc is
- Which of the following types of riveted joint is free from bending stresses?
- If M is the moment due to a couple in a bearing plate whose width is b and allowable bending stress is P, the thickness (t) of the bending plate of the column splice, is

Login to Continue

It will take less than 2 minutes

Report MCQ