The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called

Related MCQs

• If the floor is supported at or near the bottom but top chords of a bridge is not braced, then the bridge is called
• The thickness of the web of a mild steel plate girder is less than d/200. If only one horizontal stiffener is used, it is placed at
• The bracing provided in the plane of end posts is called
• In a built up beam actual bending compressive stress fbc is given by (when y1 is the distance of the edge of the beam from the neutral axis).
• A fillet weld whose axis is parallel to the direction of the applied load, is known as
• In a truss girder of a bridge, a diagonal consists of mild steel flat 4001.S.F. and carries a pull of 80 tonnes. If the gross-diameter of the rivet is 26 mm, the number of rivets required in the splice, is
• The distance between e.g. of compression and e.g. of tension flanges of a plate girder, is known as
• When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).
• In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon:
• By providing sufficient edge distance, which of the following failures of riveted joint can be avoided?