[Solved] The d.c. series motor should always be started with load because

Q.	The d.c. series motor should always be started with load because
A.	at no load, it will rotate at dangerously high speed.
B.	it will fail to start.
C.	it will not develop high starting torque.
D.	all are true.
Answer» A. at no load, it will rotate at dangerously high speed.

5.5k

Do you find this helpful?

View all MCQs in

Electrical and Electronics Engineering

Discussion

No comments yet

Related MCQs

A 4 pole, 250V series motor has a wave connected armature with 1254 conductors. The flux per pole is 22mWb when the motor taking 50A. Iron and friction lossses amount to 1000W. Armature resistance 0.2Ω, series field resistance 0.2Ω. What is the speed of the motor___.
A 4 pole, 250V series motor has a wave connected armature with 1254 conductors. The flux per pole is 22mWb when the motor taking 50A. Iron and friction lossses amount to 1000W. Armature resistance 0.2Ω, series field resistance 0.2Ω. What is the output power in H.P.
A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The armature resistance is 0.2Ω and contact drop per brush is 1V. What is the full load speed of the motor?
A 220V DC series motor is taking a current of 40A. Resistance of armature is 0.5Ω and series field is 0.25Ω. What is the voltage at the brushes?
A 220V DC series motor is taking a current of 40A. Resistance of armature is 0.5Ω and series field is 0.25Ω. What is the back emf?
A 220V series motor takes a current of 35A and runs at 500rpm. Armature resistance of 0.25Ω and series field resistance 0.3Ω. If iron and frictional losses amount of 600W, what is the armature torque?
A 220V series motor takes a current of 35A and runs at 500rpm. Armature resistance of 0.25Ω and series field resistance 0.3Ω. If iron and frictional losses amount of 600W, what is the shaft torque?
A 200V DC series motor runs at 500rpm when taking a line current of 25A.The resistance of the armature is 0.3Ω and that of the series field is 0.5Ω. If current taken remains constant, calculate the resistance necessary to reduce the speed to 350rpm.
A thick wire is used in dc series motor field winding than that in dc shunt motor:
In a DC series motor increasing the load current will