If the applied voltage of dc motor is reduced to half with load torque doubled the armature current will be____

Related MCQs

• A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The armature resistance is 0.2Ω and contact drop per brush is 1V. What is the full load speed of the motor?
• A shunt motor runs at 500rpm on a 200V circuit. Its armature resistance is 0.5Ω and the current taken is 30A in addition to field current. What resistance must be placed in series with armature circuit to reduce to speed to 300 rpm; the current in armature remains same.
• The armature of a 4 pole shunt motor has a lap winding accomodated in 60 slots, each containing 20 conductors, if the useful flux per pole is 23mWb, the armature torque developed when the armature current is 50A is _____.
• A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The armature resistance is 0.2Ω and contact drop per brush is 1V. What is the back emf?
• A 220V series motor takes a current of 35A and runs at 500rpm. Armature resistance of 0.25Ω and series field resistance 0.3Ω. If iron and frictional losses amount of 600W, what is the armature torque?
• The shaft torque in a DC motor is less than total armature torque because of ____in the motor
• A 250V DC shunt motor takes a total current of 20A. Resistance of shunt field winding is 200Ω and that of armature is 0.3Ω . What is the current in the armature?
• A DC shunt motor is driving a constant torque load. On inserting an additional resistance in the armature circuit, the speed of the motor will:
• A 3 phase induction motor running with full load slip of 1.2% and its rotor impedance per phase on standstill is 0.016+j0.265Ω then the ratio of full load torque to maximum torque is
• The armature torque of a DC motor running of 800rpm is 99.3Nm and shaft torque is 93.3Nm. The iron and friction losses are__.