McqMate

Q. |
## In the figure given below, the points N1 and N2 are known as_______ |

A. | Nodes |

B. | Elastic points |

C. | Inelastic points |

D. | Breaking points |

Answer» A. Nodes |

1.4k

0

Do you find this helpful?

13

View all MCQs in

Dynamics of MachineryNo comments yet

- Consider P and Q as the shaft having two rotors at the end of it, what is the point N known as in the given figure?
- In the given figure, m1=20 Kg, m2=30Kg and m=50 Kg, if r1=0.2m and r=0.3m, l=1m, find l2.
- In the given figure, m1=10 Kg, m2=30Kg and m=50 Kg, if r=0.3m, l=1m, find l2 = 0.5m, find r1 in m.
- n the given figure if N is the node then NQ acts as which of the following system?
- In the diagram shown below, if rotor X and rotor Z rotate in same direction and rotor Y rotates in opposite direction, then specify the type of node vibration.
- Calculate equivalent stiffness of the spring for the system shown below, which has spring stiffness of 3000 N/m
- A vertical circular disc is supported by a horizontal stepped shaft as shown below. Determine equivalent length of shaft when equivalent diameter is 20 mm.
- From the given data, find the balancing mass in Kg if r=0.2m required in the same plane.Masses = 200kg, 300kg, 240 kg, 260Kg, corresponding radii = 0.2m, 0.15m, 0.25m and 0.3m.Angles between consecutive masses = 45, 75 and 135 degrees.
- The periodic time is given by _______.
- From the given data, find the balancing mass’s inclination in degrees if r=0.2m required in the same plane.Masses = 200kg, 300kg, 240 kg, 260Kg,