[Solved] The no load current of the induction motor is high due to

McqMate

Q.	The no load current of the induction motor is high due to
A.	long and high reluctance path between stator and rotor
B.	mutual flux having moderate reluctance path between stator and rotor
C.	leakage flux having low reluctance iron core
D.	leakage flux having high reluctance iron core
Answer» A. long and high reluctance path between stator and rotor
Explanation: it is due to the higher

2.8k

0

Do you find this helpful?

13

View all MCQs in

Electrical Drives and Controls (EDC)

Discussion

No comments yet

Related MCQs

No load current in induction motor is 10- 20% of full load current and the no load current of transformer is 2-6%.
The no load current of the induction motor is high due to
For a 7.46 kW, 200 V dc shunt motor with full load efficiency of 85% has armature resistance of 0.25 ohms. Calculate the value of starting resistance in ohms for a current 1.5 times of the full load current.
A 50 Hz, 4poles, a single phase induction motor is rotating in the clockwise direction at a speed of 1425 rpm. The slip of motor in the direction of rotation & opposite direction of the motor will be respectively.
An induction motor when started on load, it does not accelerate up to full speed but runs at 1/7th of the rated speed. The motor is said to be
An induction motor when started on load, it does not accelerate up to full speed but runs at 1/7th of the rated speed. The motor is said to be
An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm. The frequency of the rotor current of the motor in Hz is
An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm. The frequency of the rotor current of the motor in Hz is
A 2-pole, 3-phase, Hz induction motor is operating at a speed of 550 rpm. The frequency of the rotor current of the motor in Hz is 2.
motor. The maximum allowable current is 55 A and the minimum current is about 35 A. The armature resistance of the motor is 0.4 Ω. What will be the number of sections of starter resistance required?