If the stroke punch is 100mm, find the radius of the crank in mm.

Related MCQs

• In a slider crank mechanism, the length of the crank and connecting rod are 180 mm and 540 mm respectively. The crank position is 45° from inner dead centre. The crank shaft speed is 450 r.p.m. (clockwise), calculate angular velocity of the connecting rod in rad/s.
• The relation between stroke punch s and radius of crank r is  
• Crank effort is the product of crank pin radius and  
• For the given data of an Internal combustion engine : Mass of parts = 180 kg bore = 175 mm, length of stroke = 200 mm, engine speed = 500 r.p.m., length of connecting rod = 400 mm and crank angle = 60° from T.D.C, find the inertia force.
• Calculate the work done per minute by a punch tool making 20 working strokes per min when a 30 mm diametre hole is punched in 5 mm thick plate with ultimate shear strength og 450 Mpa in each stroke.
• In a locomotive, the ratio of the connecting rod length to the crank radius is kept very large in order to
• Piston effort acts along the line of stroke.
• In the turning moment diagram of a multicylinder engine, the work done during exhaust stroke is by  
• Work produced by the 4-stroke engine is less because  
• Compression stroke results in