For detection of longitudinal discontinuities a 7.6 cm (3 inches) diameter bar is magnetized in:

Related MCQs

• For a 7.6 cm (3 inches) diameter bar how much current is needed to magnetize the bar for the detection of longitudinal discontinuities:
• A bar that is 5 cm (2 inches) by 10 cm (4 inches) by 30.5 cm (12 inches) is being magnetized in the circular direction. About how many amperes are required using the perimeter approach?
• How many turns of a coil will be needed to establish a longitudinal field in a steel shaft that is 22.86 cm (9 inches) long and 7.62 cm (3 inches) in diameter? 3000 amperes magnetizing current is available, it is desired to magnetize the part in accordance with the formula NI = 45,000/(L/D):
• A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inches). If it is necessary to change the source-to-film distance to 61 cm (24 inches), what exposure time would produce a similar radiograph if all other conditions remain the same?
• How many ampere-turns are required to magnetize a part that is 40.6 cm (16 inches) long and 5 cm (2 inches) in diameter?
• What is the magnetic field strength at the surface of a 100 mm diameter bar as compared to that at the surface of a 50 mm diameter bar, each carrying 1000 amps of current?
• What is the magnetic field strength at the surface of a 25mm diameter bar as compared to that at the surface of a 50mm diameter bar, each carrying 1000 amps of current?
• What is the magnetic field strength at the surface of a 25 mm diameter bar as compared to that at the surface of a 50 mm diameter bar, each carrying 1000 amps of current?
• The lines of flux or force in a circularly magnetized ferromagnetic bar:
• A 7.6 cm (3 inches) thick test specimen is radiographed with a source having size of 1.3 cm (1/2 inch), the film is placed in contact with the test specimen. The source to film distance is 40.6 cm (16 inches).The geometric unsharpness obtained is: