If I2 be the armature current, then speed of a D.C. shunt motor is

Related MCQs

• The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be
• In a D.C. shunt motor, under the conditions of maximum power, the current inthe armature will be
• If the speed of a D.C. shunt motor is increased, the back e.m.f. of the motor will
• The speed of a D.C. shunt motor more than its full-load speed can be obtained by
• If a D.C. shunt motor is working at no load and if shunt field circuit suddenly opens
• If a D.C. shunt motor is working at full load and if shunt field circuit suddenlyopens
• The armature torque of the D.C. shunt motor is proportional to
• In a D.C. series motor, if the armature current is reduced by 50%, the torque of the motor will be equal to
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• The speed of a motor falls from 1100 r.p.m. at no-load to 1050 r.p.m. at rated load.The speed regulation of the motor is