In a D.C. generator in case the resistance of the field winding is increased, then output voltage will

Related MCQs

• The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be
• A sinusoidal voltage of 5 Hz is applied to the field of a shunt generator. The armature voltage wave
• If R2 is the resistance of secondary winding of the transformer and K is the transformation ratio then the equivalent secondary resistance referred to primary will be
• Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be
• In a D.C. generator the critical resistance can be increased by
• In a D.C. generator the critical resistance refers to the resistance of
• The critical resistance of the D.C. generator is the resistance of
• The e.m.f. induced in the armature of a shunt generator is 600 V. The armature resistance is 0.1 ohm. If the armature current is 200 A, the terminal voltage will be
• The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage
• In case of a 4-pole D.C. generator provided with a two layer lap winding with sixteen coils, the pole pitch will be