Water is flowing through a rectangular notch, having base width 500 mm and head over it is 160 mm. Find discharge of notch if Cd = 0.6.

Related MCQs

• An inverted triangular plate is having base parallel to water surface with width 1.6 m and height 2.10 m. It is submerged in water in such a way that its base is 1.0 m below free surface. Find total pressure.
• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5 m/s.
• Determine the head over sill of a 90° V-notch when the discharge passing over it is 100 lit/sec. consider Cd 0.6.
• A rectangular notch gives more accurate results for low discharges than a triangular notch.
• Only one reading, i.e. head (H) is required to be taken for the measurement of discharge in a triangular notch.
• The equation of rectangular notch is deal with H is
• A pipe line is 6 km long and having 20 cm diameter connect two reservoir 'A' and 'B'. The rate of discharge in the pipe is 30 lit/sec. Find out the difference in reservoir levels if friction factor f = 0.0008.
• Liquid is flowing through 200 mm diameter tube with mean velocity of 2 m/sec. If density of liquid is 912 kg/m3 and viscosity is0.38 N.S/m2 find type of flow.
• A simple manometer containing mercury is used to measure pressure of oil (sp. gr. 0.8) flowing in a pipe as shown below. Mercury level in open tube is 150 mm higher than that on left limb. If height of oil in left limb is 90 mm, determine the pressure in terms of head of water in a pipe.
• The diameters of a pipe at the sections 1 and 2 are 10 cm and15 cm respectively. The velocity of water flowing through the pipe at section 1 is 5 m/s. Determine the velocity at section 2.