[Solved] The curve between V and I of SCR when anode is positive w.r.t cathode and when anode is negative w.r.t cathode are known as

McqMate

Q.	The curve between V and I of SCR when anode is positive w.r.t cathode and when anode is negative w.r.t cathode are known as
A.	both as forward characteristics
B.	both as reverse characteristics
C.	former as forward characteristics and later as reverse characteristics
D.	former as reverse characteristics and later as forward characteristics
Answer» C. former as forward characteristics and later as reverse characteristics

2.3k

0

Do you find this helpful?

18

View all MCQs in

Power Electronics

Discussion

No comments yet

Related MCQs

An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
In case of the two-transistor model (T1 & T2) of GTO with anode-short, the anode-short is placed between the
A single-phase voltage controller, using one SCR in anti parallel with a diode, feeds a load R and Vs = 230 V. For a firing angel of 90° for the SCR, the PMMC voltage connected across R would read
Anode of an operational SCR is
With gate open, the maximum anode current at which SCR is turned off from ON condition is called
In an SCR, the anode current is controlled by
In an SCR, the anode current consists of
A resistor connected across the gate and cathode of an SCR in a circuit increases its
In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
A single phase voltage controller has input of 230 V and a load of 15 Ω resistive. For 6 cycles on and 4 cycles off, determine the average value of SCR current.