The rms value of the complex voltage given by v = 161i sin cot + 12 Ari sin Rot is

Related MCQs

• The principal information obtained from load flow studies in a power system are 1. magnitude and phase angle of the voltage at each bus. 2. reactive and real power flows in each of lines. 3. total power loss in the network. 4. Transient stability limit of the system Select the correct answer from the codes given below :
• The positive and negative halves of a complex wave are symmetrical when
• Two complex waves will have the same wave-shape if
• The trigonometric Fourier series for a complex wave will contain positive cosine terms only when
• In an R-L circuit connected to an alternating sinusoidal voltage, size of transient current primarily depends on
• The positive sequency component of voltage at the point of fault is zero when it is a :
• The in-rush current of a transformer at no load is maximum if the supply voltage is switched on
• Which fractional pitch will eliminate the seventh harmonic from the voltage waveform of an alternator?
• Which of the following is not considered as good power quality voltage
• The most common way to calculate voltage sag is from ______