The positive sequency component of voltage at the point of fault is zero when it is a :

Related MCQs

• For measuring positive, negative and zero sequence voltages in a system, the reference is taken as :
• Consider the following statements : The transient stability of the power system under unbalanced fault conditions can be effectively improved by 1. Excitation control 2. phase-shifting transformer 3. single-pole switching of circuit breakers 4. increasing the turbine input. Of these statements
• Current-limiting fuses are able to clear a fault within one _______.
• The positive and negative halves of a complex wave are symmetrical when
• The trigonometric Fourier series for a complex wave will contain positive cosine terms only when
• The rms value of the complex voltage given by v = 161i sin cot + 12 Ari sin Rot is
• In an R-L circuit connected to an alternating sinusoidal voltage, size of transient current primarily depends on
• The in-rush current of a transformer at no load is maximum if the supply voltage is switched on
• The principal information obtained from load flow studies in a power system are 1. magnitude and phase angle of the voltage at each bus. 2. reactive and real power flows in each of lines. 3. total power loss in the network. 4. Transient stability limit of the system Select the correct answer from the codes given below :
• Which fractional pitch will eliminate the seventh harmonic from the voltage waveform of an alternator?