- Civil Engineering
- Design of Steel Structures
- If L is the overall length of a combined...

Q. |
## If L is the overall length of a combined footing having A as its area, d being the distance between the centre of gravity of the base and centre of the base, the larger width b is |

A. | (A/L) + (3Ad/L²) |

B. | (A/L) + (6Ad/L²) |

C. | (A/L) - (6Ad/L²) |

D. | (A/L) - (3Ad/L²) |

Answer» B. (A/L) + (6Ad/L²) |

View all MCQs in:
Design of Steel Structures

- If L is the overall length of a combined footing having A as its area, d being the distance between the centre of gravity of the base and centre of the base, the larger width b is
- For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to
- For the economical design of a combined footing to support two equal column loads, the projections of beams in lower tier are kept such that bending moment under column is equal to
- To keep the intensity of bearing pressure between the column base and concrete, compressive throughout the length of the column base, the ratio of the moment M to axial load P should be
- An axial loaded column is supported on a slab base whose projection is 8 cm. If the intensity of pressure from concrete is 40 kg/cm2 and allowable bending stress in slab base is 1890 kg/cm2 , the thickness (t) of the slab base, is
- If the thickness of a structural member is small as compared to its length and width, it is classified as
- If the thickness of a structural member is small as compared to its length and width, it is classified as
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called
- In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate

Login to Continue

It will take less than 2 minutes

Report MCQ