As per IS : 456, the reinforcement in a column should not be less than

Related MCQs

• The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than
• According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than
• According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than
• If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
• Minimum spacing between horizontal parallel reinforcement of the same size should not be less than
• The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
• Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than
• An R.C.C. column is treated as short column if its slenderness ratio is less than
• If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than
• As per I.S. 456 - 1978, the pH value of water shall be