The zone in which transverse bending is likely to occur may be obtained by drawing a line from the

Related MCQs

• If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
• The spacing of transverse reinforcement of column is decided by the following consideration.
• The transverse reinforcements provided at right angles to the main reinforcement
• The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
• In the zone of R.C.C. beam where shear stress is less than 5 kg/cm2 , nominal reinforcement is provided at a pitch of
• The modular ratio m of a concrete whose permissible compressive stress is C, may be obtained from the equation.
• If is the net upward pressure on a square footing of side for a square column of side , the maximum bending moment is given by
• is the pre-stressed force applied to tendon of a rectangular pre-stressed beam whose area of cross section is and sectional modulus is. The minimum stress on the beam subjected to a maximum bending moment is
• The design of heel slab of a retaining wall is based on the maximum bending moment due to:
• If longitudinally spanning stairs are casted along with their landings, the maximum bending moment per metre width, is taken as