By over-reinforcing a beam, the moment of resistance can be increased not more than

Related MCQs

• A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n1. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
• is the pre-stressed force applied to tendon of a rectangular pre-stressed beam whose area of cross section is and sectional modulus is. The minimum stress on the beam subjected to a maximum bending moment is
• is the pre-stressed force applied to the tendon of a rectangular pre-stressed beam whose area of cross section is and sectional modulus is . The maximum stress in the beam, subjected to a maximum bending moment , is
• If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
• In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called
• To ensure that the hogging bending moment at two points of suspension of a pile of length L equals the sagging moment at its centre, the distances of the points of suspension from either end, is
• A reinforced concrete cantilever beam is 3.6 m long, 25 cm wide and has its lever arm 40 cm. It carries a load of 1200 kg at its free end and vertical stirrups can carry 1800 kg. Assuming concrete to carry one-third of the diagonal tension and ignoring the weight of the beam, the number of shear stirrups required, is
• For M 150 grade concrete (1:2:4) the moment of resistance factor is
• Dimensions of a beam need be changed if the shear stress is more than
• An R.C.C beam of 25 cm width has a clear span of 5 metres and carries a U.D.L. of 2000kg/m inclusive of its self weight. If the lever arm of the section is 45 cm., the beam is