Effective length of a weld is equal to

Related MCQs

• The effective length of a fillet weld designed to transmit axial load shall not be less than
• A strip of steel (E = 200 GPa, 0.25) has a length of 1 m, width of 200 mm and thickness of 10 mm. A line of length 1 m is drawn parallel to its length on one of its side surfaces. When the strip is subjected to an axial tensile force of 100 kN, the length of the line will be                  mm.
• A beam of overall length 1 with equal overhangs on both sides carries a uniformly distributed load over the entire length. To have numerically equal bending moments at centre of the beam and at supports, the distance between the supports should be
• A beam of overall length / rests on two simple supports with equal overhangs on both sides. Two equal loads act at the free ends. If the deflection at the centre of the beam is the same as at either end, then the length of either overhang is
• When two shafts of same length, one of which is hollow, transmit equal torques and have equal maximum stress, then they should have equal
• Effective throat thickness of a fillet weld is
• Size of fillet weld with unequal legs is equal to
• The change in length of a rod of uniform circular cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of half the diameter subjected to the same force will be Mm
• The change in length of a rod of uniform cross section was found to be 2 mm for some applied force. The change in length of a rod of the same material and length but of twice the cross section area subjected to the same force will be__ mm.
• The maximum bending moment of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length lies at the middle of its length.