According to Unwin's formula, the dia¬meter of rivet in mm to suit the t mm thickness of plate is given by

Related MCQs

• A flat carrying a pull of 69C kN is con-nected to a gusset plate using rivets. If the pulls required to shear the rivet, to crush the rivet and to tear the plate per pitch length are 68.5 kN, 46 kN and 69 kN respectively, then the number of rivets required is
• A boiler shell 100 cm diameter and plate thickness 12 mm is subjected to an internal pressure of 1.2 N/m2. The hoop stress will be
• For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
• With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
• If the rivet value is 16.8 kN and force in the member is 16.3 kN, then the number of rivets required for the connection of the member to a gusset plate is
• The distance between the centre of a rivet hole to the nearest edge of plate, is called
• If the rivet value is 2000 N and the force in the member is 2000 N, the number of rivets required for the connection of the member to a gusset plate is
• If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
• For a 25 mm hole drilled in plates, the diameter of rivet shank should be
• Two shafts 'A' and 'B' have the same material. The shaft 'A' is solid of diameter 100 mm. The shaft 'B' is hollow with outer diameter 100 mm and inner diameter 50 mm. The torque transmitted by shaft 'B' is