Absorption factor, for a fixed degree of absorption from a fixed amount of gas should be

Related MCQs

• With increase in solvent rate, the number of transfer units, NtoG, for a fixed degree of absorption from a fixed amount of gas
• With increase in gas rate, the number of transfer units, NtoG, for a fixed degree of absorption by a fixed amount of solvent
• With increase in the liquid flow rate at a fixed gas velocity in a randomly packed counter current gas-liquid absorption column, the gas pressure drop
• For the gas absorption, the height of a transfer unit, based on the gas phase is given by (G: superficial molar gas velocity, L: superficial molar liquid velocity, FG: mass transfer co-efficient, moles/m2, a: interfacial area per unit volume of tower)
• In a gas-liquid absorption column, for obtaining the maximum absorption efficiency
• Absorption (liquid-gas system) with evolution of heat as compared to isothermal absorption results in
• In a packed absorption tower, if the equilibrium and operating lines are both straight lines, then the ratio, HETP/HTUOG __________ the absorption factor.
• H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in metres) corresponding to an operating line given by, y = 5x + 0.001 is
• The interfacial area per unit volume of dispersion, in a gas-liquid contactor, for fractional hold up of gas = 0.1 and gas bubble diameter = 0.5 mm is given by (in m2 /m3 )
• To increase the absorption factor, (where, G = gas flow rate, S = solvent flow rate)