Acetone is to be removed from air in an isothermal dilute absorber using pure water as solvent. The incoming air contains 5 mole% of acetone (yin = 0.05). The design equation to be used for obtaining the number of trays (N) of the absorber is, N+2 = 6 log (yin/yout).For 98% recovery of acetone, the number of trays required is/are:

Related MCQs

• Experiments were conducted to determine the flux of a species A in a stagnant medium across a gas-liquid interface. The overall mass transfer co-efficient based on the liquid side for dilute systems for the above was estimated to be 4 × 10-3 kg mole/m2 .s. The equilibrium data for the system is given as y = 2x. The flux across the interface (in kg mole/m2 .s) for bulk concentrations of A in gas phase and liquid phase as y = 0.4 and x = 0.01 respectively is:
• In a liquid-liquid extraction, 10 kg of a solution containing 2 kg of solute C and 8 kg of solvent A is brought into contact with 10 kg of solvent B. Solvent A and B are completely immiscible in each other whereas solute C is soluble in both the solvents. The extraction process attains equilibrium. The equilibrium relationship between the two phases is Y* = 0.9X, where Y* is the kg of C/kg of B and X is kg of C/kg of A. Choose the correct answer.
• Compound A is extracted from a solution of A + B into a pure solvent S. A Co-current unit is used for the liquid-liquid extraction. The inlet rate of the solution containing A is 200 moles of B/hr.m2 and the solvent flow, rate is 400 moles of S/m2 . hr. The equilibrium data is represented by Y = 3X2 , where Y is in moles of a A/moles of B and X is in moles A/moles of S. The maximum percentage extraction achieved in the unit is
• When acetone is added in a two layer mixture of methyl isobutyl ketone and water at 30°C, the acetone distributes between the two layers and the composition of the layer follows two solubility curves. For this system,
• H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in metres) corresponding to an operating line given by, y = 5x + 0.001 is
• The slope of the operating line for a single component co-current absorber when plotted in terms of mole ratio units is
• At equilibrium the concentration of water in vapour phase (C*) in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C* = 0.0667m. To maintain dry conditions in a room of air space 100m3 containing 2.2 kg of water vapour initially, 10 kg of dry silica gel is kept in the room. The fraction of initial water remaining in the air space after a long time (during which the temperature is maintained constant) is
• If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is
• In a solution containing 0.30 Kg mole of solute and 600 kg of solvent, the molality is
• Selectivity of the solvent used in solvent extraction should be