McqMate

Q. |
## The frictional torque produced due to friction for same shaft diameter, in conical bearing is____. |

A. | less than that for flat collar bearing |

B. | equal to that for flat collar bearing |

C. | more than that for flat collar bearing |

D. | may be more or less depending upon cone angle |

Answer» C. more than that for flat collar bearing |

1.1k

0

Do you find this helpful?

4

View all MCQs in

Theory of MechanicsNo comments yet

- For uniform pressure the ratio of frictional torque for a flat collar bearing to the frictional torque for conical collar bearing is equal to____. Where ϴ=semi-angle of the cone
- For uniform wear, the ratio of frictional torque for a flat collar bearing to the frictional torque for conical collar bearing is equal to____. Where ϴ=semi-angle of the cone
- Following are the details pertaining to thrust bearing 1) External and internal dia of contacting surfaces-320 mm and 200 mm resp. 2) Axial load-80 kN 3)Pr. Intensity-350 kN/m2 4) shaft speed-400 rpm 5)coefficient of friction-0.06 Calculate power lost in overcoming friction. the frictional torque and power lost in frictional
- A flat foot step bearing 225 mm in diameter supports a load of 7500 N. If the co-efficient of friction is 0.09 and the shaft rotates at 60 rpm, calculate the power lost in frictional torque and frictional power in watts with uniform pressure is ___.
- A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
- A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
- The frictional torque for the same diameter in a conical bearing is ____.
- A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1.The friction torque and frictional power in watts with uniform pressure are respectively.
- A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1. The friction torque and frictional power in watts with uniform wear are respectively.
- The ratio of frictional torque produced for uniform wear to frictional torque produced for uniform pressure is ____.