Following are the details pertaining to thrust bearing 1) External and internal dia of contacting surfaces-320 mm and 200 mm resp. 2) Axial load-80 kN 3)Pr. Intensity-350 kN/m2 4) shaft speed-400 rpm 5)coefficient of friction-0.06 Calculate power lost in overcoming friction. the frictional torque and power lost in frictional

Related MCQs

• A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
• A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction would be equal to ____.
• A flat foot step bearing 225 mm in diameter supports a load of 7500 N. If the co-efficient of friction is 0.09 and the shaft rotates at 60 rpm, calculate the power lost in frictional torque and frictional power in watts with uniform pressure is ___.
• A flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The power lost in overcoming friction at the bearing, will be equal to ___.
• A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
• A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1.The friction torque and frictional power in watts with uniform pressure are respectively.
• A flat footstep bearing 10 cm radius supports a load of 3 kN. The shaft runs at 600/π r.p.m. and co-efficient of friction is 0.1. The friction torque and frictional power in watts with uniform wear are respectively.
• For uniform pressure the ratio of frictional torque for a flat collar bearing to the frictional torque for conical collar bearing is equal to____. Where ϴ=semi-angle of the cone
• For uniform wear, the ratio of frictional torque for a flat collar bearing to the frictional torque for conical collar bearing is equal to____. Where ϴ=semi-angle of the cone
• A flat foot step bearing 20 cm in diameter supports a load of 2500 kgf. The shaft is running at 420 rpm and the co-efficient is 0.09. The frictional torque, for uniform pressure, will be equal to ___.