In a simple band brake applied to a shaft carrying a flywheel of mass 250kg and radius of gyration 350mm , one end of the band is attached to the fulcrum and the other at a distance 300 mm from the fulcrum. The angle embraced by the band is 2250 and the brake drum diameter is 220 mm coefficient of friction 0.25 and the shaft speed is 300 rpm clockwise. Determine the brake torque when a force of 150 N is applied

Related MCQs

• A single block brake as shown in Fig.6 has a brake drum diameter of 1m and the angle of contact is 300. It takes 280 Nm torque at 300rpm. The coefficient of friction is 0.35. Determine the required force 'P' to be applied when the rotation of drum is clockwise.
• In a band brake the ratio of tight side band tension to the tension on the slack side is 3. If the angle of band on the drum is 1800 the coefficient of friction required between drum and band is_____
• In a block brake, when the fulcrum point is below the line of action of friction point, the ratio of effort required for clockwise and counter clockwise rotation is____.
• A conical pivot supports a load of 20 kN, and its semicone angle is 41.81 degree. The friction coefficient is 0.06 and shaft runs at 200 rpm. The torque required to overcome friction and power lost in friction is
• Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 10 degree and coefficient of friction 0.25.
• Determine the axial force required to engage a cone clutch transmitting 25 kW power at 750 rpm. Average friction diameter of the cone is 400 mm, semicone angle 60 degree and coefficient of friction 0.25.
• A thrust bearing having collars of external and internal diameter as 40 cm and 20 cm respectively, carries an axial load of 3000 N. The co-efficient of friction is 0.09 and shaft runs at 420 rpm. The power lost in friction is to be determined. The corresponding value of friction torque would be ____.
• Following are the details pertaining to thrust bearing 1) External and internal dia of contacting surfaces-320 mm and 200 mm resp. 2) Axial load-80 kN 3)Pr. Intensity-350 kN/m2 4) shaft speed-400 rpm 5)coefficient of friction-0.06 Calculate power lost in overcoming friction. the frictional torque and power lost in frictional
• The following data refer to a laboratory experiment with rope brake____.Diameter of the flywheel=1m Diameter of the rope = 10mm , Dead weight on the brake = 50kg , Speed of the engine = 200rpm , Spring balance reading = 120N . Find brake power of the engine.
• In a simple band brake, when direction of rotation of drum is changed from counter clockwise direction, the braking torque____.