A rail 20 m long is prevented from expansion at both end . If the temperature is raised by 30 0C, Stress induced in rail is.. E=200 Gpa,α =12x10-6/°C

Related MCQs

• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of CD is mm.
• The axially loaded composite rod shown in Fig. 1.2 has a uniform cross- sectional area of 500 mm 2 . The modulii of elasticity are Est = 200 GPa, Eal = 70 GPa and Ecu = 120 GPa. The change in length of the composite rod is mm.
• A copper rod 15 mm diameter 0.8 m long is heated through 50?C. The expansion of the rod is prevented by gripping it at both ends. When the grips do not yield, the stress in rod is 115 N/mm2 and forces applied at the grips are 20 kN. In case one of the grip yields by 0.5 mm
• When a bar is subjected to a change of temperature and its deformation is prevented, which of the following stress is induced?
• When a bar is subjected to a change of temperature and its deformation is prevented, the stress induced in the bar is
• At a point in a steel member, the major principal stress is 2000 kg/cm2 and the minor principal stress is compressive. If the uni-axial tensile yield stress is 2500 kg/cm2, then the magnitude of the minor principal stress at which yielding will commence, according to the maximum shearing stress theory, is
• A steel rod of 3m is manufactured at 250C the temperature of rod is increases to 1250C. If free expansion is 3.6mm, what is the temperature stresses produced if 1.5mm expansion is permitted?
• A steel bar ABC (E = 200 GPa) is 1 m long. For AB = 0.7 m, it has cross section P area of 500 mm2 and for BC = 0.3 m the cross section area is 400 mm2. The bar is subjected to an axial pull of 100 kN. The stress is maximum in ___ _
• In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress is always a tensile stress where as the radial stress is a compressive stress
• A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be